Skip to content

E-Check: obligations, inspection intervals and costs

Technically reviewed by Reinlicht Elektrotechnik, as of 31 October 2026

The short answer

The inspection of the electrical installation, often called an E-Check (electrical safety inspection), is mandatory for businesses but not for owner-occupied flats and houses. Businesses inspect under DGUV Vorschrift 3 and the Betriebssicherheitsverordnung; for fixed installations the DGUV gives an interval of four years. Landlords must act on specific defects and may pass the inspection costs on to tenants only with a clause in the tenancy agreement.

What does an E-Check cover?

During an E-Check (electrical safety inspection), a qualified electrician (Elektrofachkraft) checks whether the electrical installation is safe. It is based on two standards: DIN VDE 0100-600 for the initial verification of a new or altered installation, and DIN VDE 0105-100 for periodic inspection during operation. Under DIN VDE 0105-100, the inspection has three parts: visual inspection, functional testing and measurement.

  • Visual inspection: condition of distribution boards, cables, socket outlets and switches, labelling, visible damage.
  • Functional testing: operation of residual current devices (RCDs) and other protective devices.
  • Measurement: for example insulation resistance, protective earth conductor and disconnection conditions of the circuits.

Previous test reports feed into the assessment. If they are missing, DIN VDE 0105-100 (since amendment A1 of 2017) first requires a preliminary investigation, with a scope based on the initial verification under DIN VDE 0100-600. The result of the inspection and the measures taken against defects found are recorded in writing.

Note: If the inspection finds an immediate hazard, the defect must be remedied at once. If that is not possible, the affected part of the installation is taken out of service.

Is the E-Check mandatory for businesses?

For businesses, inspecting the electrical installation is mandatory; the name E-Check is not. Under § 5 of DGUV Vorschrift 3 (DGUV V3, the German statutory accident insurance regulation for electrical equipment), the employer must have electrical installations and equipment inspected: before first commissioning, after alteration or repair, and thereafter at specified intervals. The Betriebssicherheitsverordnung (BetrSichV, German Ordinance on Industrial Safety and Health) requires the same for work equipment. The employer sets the intervals in the risk assessment.

E-Check is not a term from any law or standard. It is the name under which the electrical trade, through its central association ZVEH, promotes installation inspections. Legally, all that counts is that the inspection is carried out under DGUV Vorschrift 3 and the DIN VDE standards named above and that the result is documented. An inspection under DGUV Vorschrift 3 fulfils the obligation even without an E-Check label.

Inspection intervals under DGUV Vorschrift 3, implementation guidance to § 5 (extract)
Installation or equipmentIntervalInspected by
Electrical installations and fixed equipment4 yearsQualified electrician
Installations in special locations (DIN VDE 0100 Group 700)1 yearQualified electrician
Residual current devices in fixed installations, test via test button6 monthsUser
Portable equipment and extension leadsGuideline 6 months, construction sites 3 months; maximum in offices 2 yearsQualified electrician or electrically instructed person with suitable measuring equipment

The values in the table are guidelines. If an inspection shows that an item of work equipment will not remain safe until the next date, a shorter interval must be set.

Do owners and landlords need an inspection?

There is no statutory obligation to carry out an E-Check in owner-occupied flats and houses. Nevertheless, under § 13 of the Niederspannungsanschlussverordnung (NAV, the German Low Voltage Connection Ordinance), the connection owner (Anschlussnehmer), usually the property owner, is responsible for the proper maintenance of the installation downstream of the service fuse (Hausanschlusssicherung).

Landlords must ensure that the rented property is safe. However, the Federal Court of Justice (Bundesgerichtshof) does not require a regular general inspection without cause (judgment of 15 October 2008, VIII ZR 321/07). If there are specific indications of defects, such as tripping fuses, scorch marks or a very old installation, the landlord must have the installation inspected and repaired.

No standard sets a fixed inspection interval for private homes. DIN VDE 0105-100 leaves the intervals to the operator. The four years that the DGUV specifies for fixed installations in businesses are often used as a reference. Regardless of any interval, these situations call for an inspection:

  • when buying a second-hand house or flat
  • when tenants change
  • before connecting large loads such as a wallbox (EV charger), heat pump or photovoltaics
  • after water damage, fire or overvoltage
  • when residual current devices or fuses trip for no apparent reason

What does an E-Check cost, and who pays?

The cost of an E-Check depends on the size of the installation and the number of circuits, and for businesses also on the number of portable devices. We quote a binding price after the site visit.

Landlords may pass the cost of the inspection on to tenants if the tenancy agreement provides for it. The Federal Court of Justice classified the regular inspection of the electrical installation as other operating costs (sonstige Betriebskosten) under § 2 No. 17 of the Betriebskostenverordnung (German Operating Costs Ordinance), because it is not a repair (judgment of 14 February 2007, VIII ZR 123/06). The tenancy agreement must expressly list these costs as other operating costs.

Remedying defects found, by contrast, counts as repair. Under § 1 of the Betriebskostenverordnung, these costs are not operating costs and are borne by the landlord.

What does the test report contain?

The test report of an E-Check records what was inspected and with what result. DIN VDE 0105-100 requires a record of the inspection result and, where necessary, of the measures to remedy defects. For businesses, § 14(7) of the Betriebssicherheitsverordnung sets out the minimum content: type, scope and result of the inspection, plus the name and signature of the inspecting person.

  • installation or equipment inspected and reason for the inspection
  • standards applied, such as DIN VDE 0105-100 or DIN VDE 0100-600
  • results of visual inspection, functional testing and measurement, with the measured values for each circuit
  • defects found and the measures taken
  • date, name and signature of the inspecting person

Under the Betriebssicherheitsverordnung, businesses keep the record at least until the next inspection. Private households have no obligation to keep records, but a report documents the condition of the installation, for example when selling or in dealings with the insurer.

Does the insurer require an E-Check?

For private households, insurance law does not prescribe an E-Check. However, if someone causes damage through gross negligence, the insurer may reduce its payment under § 81 of the Versicherungsvertragsgesetz (VVG, German Insurance Contract Act). Anyone who ignores known electrical defects takes this risk. An up-to-date test report documents the condition of the installation.

Commercial fire insurance policies often include clause SK 3602. It requires an inspection to guideline VdS 2871 by VdS-approved experts. This inspection does not replace the inspection under DGUV Vorschrift 3. The terms of your policy are decisive.

How to prepare for the inspection

For the E-Check, the qualified electrician needs access to all distribution boards and to the documents on the installation. Reinlicht Elektrotechnik is an electrical contractor based in Taufkirchen and inspects installations in flats, houses and businesses under DIN VDE 0105-100 and DGUV Vorschrift 3, fixed installations as well as portable equipment.

  • previous test reports; if they are missing, the electrician schedules the preliminary investigation
  • circuit diagrams or circuit labelling, where available
  • list of special locations, such as bathroom, sauna or outdoor areas
  • for businesses: risk assessment and list of portable equipment
  • time windows in which individual circuits may be switched off briefly

For the measurements, the electrician switches off circuits one after another. In businesses, the inspection can be split into sections so that servers, cooling or machines keep running. Defects found are listed in the report. You decide whether and when to have them remedied; in the case of an immediate hazard, the affected part must be taken out of service at once.

Frequently asked questions

The most common questions, answered briefly. If yours is not among them, call us or send an enquiry.

Is an E-Check mandatory for owners of an owner-occupied flat?

No. There is no statutory inspection obligation for private households. As the owner, you nevertheless remain responsible for a safe installation.

Can I demand an E-Check as a tenant?

The Federal Court of Justice has ruled out a right to regular inspection without cause. If there are specific indications of defects, the landlord must have the installation inspected and repaired.

Who may carry out an E-Check?

The inspection should be carried out by a qualified electrician with experience in inspecting comparable installations. Portable equipment may also be inspected by an electrically instructed person using suitable measuring equipment.

How long does an E-Check take?

That depends on the number of circuits and devices. For a flat, one appointment is usually enough; in businesses the inspection is often planned in sections.

Does an extension of the installation have to be inspected?

Yes. After an alteration or extension, the installer inspects the altered parts under DIN VDE 0100-600 before they go into operation. This applies to businesses and private households alike.

What happens if the inspection finds a dangerous defect?

Under DIN VDE 0105-100, a defect posing an immediate hazard is remedied without delay. If that is not possible, the affected part of the installation has to stay out of service until it has been repaired.

Sources

Laws, standards and figures change. We checked the information as of the date given; the linked original sources are authoritative. This article does not replace advice on your specific case.

  1. BGN: DGUV Vorschrift 3, Paragraf 5 Prüfungen mit Durchführungsanweisung (Tabellen 1A und 1B) (opens in a new tab) accessed on 30 October 2026
  2. Bundesministerium der Justiz: Betriebssicherheitsverordnung, Paragraf 14 Prüfung von Arbeitsmitteln (opens in a new tab) accessed on 31 October 2026
  3. Bundesministerium der Justiz: Niederspannungsanschlussverordnung, Paragraf 13 Elektrische Anlage (opens in a new tab) accessed on 30 October 2026
  4. Bundesministerium der Justiz: Betriebskostenverordnung, Paragraf 2 Nr. 17 sonstige Betriebskosten (opens in a new tab) accessed on 30 October 2026
  5. Bundesministerium der Justiz: Betriebskostenverordnung, Paragraf 1 Betriebskosten (Abgrenzung zur Instandsetzung) (opens in a new tab) accessed on 30 October 2026
  6. dejure.org: BGH, Urteil vom 14.02.2007, VIII ZR 123/06 (Kosten der Elektroanlagenprüfung als Betriebskosten) (opens in a new tab) accessed on 30 October 2026
  7. dejure.org: BGH, Urteil vom 15.10.2008, VIII ZR 321/07 (keine regelmäßige Generalinspektion ohne Anlass) (opens in a new tab) accessed on 30 October 2026
  8. Bundesministerium der Justiz: Versicherungsvertragsgesetz, Paragraf 81 Herbeiführung des Versicherungsfalles (opens in a new tab) accessed on 30 October 2026
  9. WEKA: Wiederholungsprüfung neu geregelt, DIN VDE 0105-100/A1:2017-06 (opens in a new tab) accessed on 31 October 2026
  10. DIN Media: DIN VDE 0100-600, Errichten von Niederspannungsanlagen, Prüfungen (opens in a new tab) accessed on 30 October 2026
  11. WEKA: VdS-Prüfung von elektrischen Anlagen (Klausel SK 3602, VdS 2871) (opens in a new tab) accessed on 30 October 2026
  12. ArGe Medien im ZVEH: Der E-CHECK (Verbraucherseite des Elektrohandwerks) (opens in a new tab) accessed on 31 October 2026

Questions about your installation?

Call us or send an enquiry. We will assess the situation on site and tell you what is needed.

Call now 24/7 emergency service, Phone: +49 151 61844537Request a quote