Skip to content

Smart home and KNX in Munich

Lighting, blinds and heating that adapt to your daily routine: planned as KNX in new builds or wireless in existing buildings.

Finger turning the dial of a black touch control panel on a white wall
Illustrative image

What it covers

We plan and install smart home systems in Munich and the surrounding area: KNX as the wired standard for new builds and renovations, and wireless systems for retrofitting existing buildings. Lighting, shading and heating are controlled by push buttons, app or time schedules.

  1. KNX

    The open standard for building automation: a dedicated bus cable connects push buttons, actuators and sensors. Manufacturer-independent and expandable later.

  2. Wireless systems

    For flats and houses where no new cables are to be laid. Wireless actuators sit behind existing switches and sockets.

  3. Lighting, shading and heating

    Lighting scenes, blinds that follow the position of the sun and room-by-room heating control. We define the functions together with you.

  4. Visualisation

    A wall-mounted control panel or an app shows the status of the house and controls it, also when you are away.

  5. Retrofitting existing buildings

    We check what your existing installation allows and extend it step by step, room by room.

Does this fit your project? Call us or send an enquiry. We reply within 24 hours and come to look at the situation on site.

How it works

Every job follows the same four steps, whatever its size.

  1. Consultation

    We look at the building and the installation on site and agree with you on what is needed.

  2. Planning

    We define scope, materials and schedule. You receive a written quote.

  3. Installation

    Our team installs to plan and coordinates with you and the other trades.

  4. Inspection

    We test the installation, record the measured values and hand it over to you with a test report.

Frequently asked questions

The most common questions, answered briefly. If yours is not among them, call us or send an enquiry.

KNX or wireless: which suits my house?

KNX suits new builds and full refurbishments, because cables are being laid anyway. In an occupied existing building, a wireless system is often the quicker solution. We advise you after looking at your installation.

Can a smart home be retrofitted in an existing building?

Yes, usually with wireless actuators in existing switch boxes. How much can be retrofitted depends on your existing installation.

Does the house work without the internet?

With KNX, yes. Control runs over the bus cable in the house, so push buttons and automation work without an internet connection. Only remote access via the app needs a connection.

Can I extend the system later?

Yes. If we plan spare capacity in the cabling and distribution board, further rooms and functions can be added later.

Discuss your project

Call us or send an enquiry. We arrange an appointment and come to look at the situation on site.

Call now 24/7 emergency service, Phone: +49 151 61844537Request a quote