Skip to content

Registering a balcony solar system: rules and limits

Technically reviewed by Reinlicht Elektrotechnik, as of 31 October 2026

The short answer

A balcony solar system (plug-in solar) only has to be registered in the Bundesnetzagentur's Marktstammdatenregister, no later than one month after commissioning. You only have to register it with the grid operator as well if the inverter exceeds 800 VA or the modules exceed 2,000 watts, a battery is connected or you want a feed-in tariff.

Which limits apply to balcony solar systems?

Two limits apply to a balcony solar system: the inverter may feed at most 800 volt-amperes (VA) into the home's wiring, and the modules may have a combined output of at most 2,000 watts. The official German term is Steckersolargerät (plug-in solar device). Only within these limits do the special rules of the Erneuerbare-Energien-Gesetz (EEG, the German Renewable Energy Sources Act) apply, including simplified registration.

In the Bundesnetzagentur's view, the limits apply to all plug-in solar devices behind the same meter combined. Two devices of 600 VA each add up to 1,200 VA and are therefore over the limit. If an inverter can be set higher by a switch or software, the highest possible value counts. If you registered a device throttled to 600 VA that can deliver 900 VA, you must correct the details.

Limits for plug-in solar devices
ParameterLimitNote
Inverter800 VAtotal of all devices on one meter
Modules on a Schuko plug960 wattsunder product standard DIN VDE V 0126-95
Modules with an energy plug-in connector2,000 wattsspecial socket, installed by a qualified electrician

Where do I register the balcony solar system?

You register a balcony solar system in the Bundesnetzagentur's Marktstammdatenregister (MaStR, the Federal Network Agency's register of energy installations), within one month of commissioning (§ 5(5) Marktstammdatenregisterverordnung). Since April 2024 the register has had a separate menu item for plug-in solar systems. Besides your personal details, it asks for only five technical values.

  1. Set up the device and put it into operation.
  2. Create a user account in the Marktstammdatenregister and select registration for plug-in solar systems.
  3. Enter module capacity, inverter capacity, location, commissioning date and electricity meter number.
  4. Complete the entry no later than one month after commissioning.

Since Solarpaket I (Solar Package I) of May 2024, a separate registration with the grid operator is no longer required. The grid operator receives a control notification about your entry from the Bundesnetzagentur. By default, the register assigns the device to unpaid offtake: you receive no payment for electricity fed into the grid, and the grid operator handles the offtake and settlement of this electricity.

Note: Balcony solar systems with battery storage are not covered by the product standard DIN VDE V 0126-95. According to the Verbraucherzentrale (consumer advice centre), the battery must also be registered with the grid operator. For a feed-in power of up to 800 watts, the application rule VDE-AR-N 4105 provides a simplified procedure using form F.1.2. Until 1 March 2027, grid operators may still apply the older version without this procedure. As of October 2026.

Does the electricity meter have to be replaced?

The electricity meter must be replaced if it cannot record feed-in separately. According to the Bundesnetzagentur, this expressly applies to balcony solar systems too. An older meter can run backwards when the device supplies more electricity than the household is using at that moment. Since Solarpaket I, this has been tolerated as a transitional measure until the meter is replaced.

An unsuitable meter must then be replaced without undue delay. The grid operator is obliged to do this without you having to order the replacement. It may fit the replacement into its rollout schedule. The new meter is either a modern metering device (moderne Messeinrichtung) working as a bidirectional meter or a smart meter (intelligentes Messsystem). Within the limits, you may connect and operate the device before the meter is replaced.

A bidirectional meter records separately how much electricity you draw from the grid and how much you feed in. Billing is then accurate again, even without payment for the electricity fed in. If the existing meter position cannot take the new meter, it has to be modified. Under § 13 NAV (Niederspannungsanschlussverordnung, the German Low Voltage Connection Ordinance), only a registered electrical contractor may carry out this work.

Is a Schuko plug enough for a balcony solar system?

A Schuko plug (standard German household plug) is enough for a balcony solar system with up to 960 watts of module capacity, provided the device complies with the product standard DIN VDE V 0126-95. The standard has applied to plug-in solar devices without storage since 1 December 2025. It is a pre-standard, meaning a standard intended to gather experience that will be reviewed later.

Compliant devices have an inverter that shuts down quickly when the plug is pulled. Above 960 watts and up to 2,000 watts of module capacity, the standard requires a special energy plug-in connector, often called a Wieland socket. If you receive a grant from your municipality, district or federal state, read the grant conditions: they may make the Wieland connector mandatory for smaller devices too.

  • No connection via multi-socket adapters or power strips: the cable can overload.
  • Under the standard, the device's connecting cable is at least 5 metres long.
  • The energy socket is installed by a qualified electrician, who also checks the circuit and adapts it if necessary.

What should you check before buying?

Most questions about a balcony solar system can be settled before you buy: connection, mounting and consent. This avoids alterations later and disputes with the landlord or neighbours. The standard DIN VDE V 0126-95 requires manufacturers to state which areas the supplied mounting system is suitable for. Read this information carefully, especially for high balconies and railings above footpaths.

  • The manufacturer confirms conformity with DIN VDE V 0126-95.
  • The module capacity matches the connection: Schuko up to 960 watts, an energy socket above that.
  • The mounting system is approved for balcony, façade or roof and withstands the wind and snow loads at the location.
  • There is a permanently installed socket nearby, with no extension via multi-socket adapters.
  • For rented property or an owners' association, written consent is in place.
  • For a device with a battery, allow for the additional registration with the grid operator.

Can the landlord prohibit a balcony solar system?

A landlord may prohibit a balcony solar system only in exceptional cases. Since October 2024, plug-in solar devices have been among the privileged structural alterations: under § 554 BGB (German Civil Code), tenants can require the landlord to permit their installation. Under § 20(2) WEG (Wohnungseigentumsgesetz, the German Condominium Act), apartment owners have a corresponding claim against the owners' association.

The landlord or the association may refuse only if the alteration cannot reasonably be expected of them. The owners' association can decide how it is done, such as location and mounting. So ask in writing before you buy, and enclose the data sheet and the planned mounting. The request can then be assessed without follow-up questions.

When do you need an electrical contractor?

You need an electrical contractor for a balcony solar system as soon as work is done on the fixed installation. You can usually connect a compliant device of up to 960 watts to a Schuko socket yourself. An energy socket, a new outdoor socket or an alteration to the meter position, on the other hand, may only be carried out by a contractor listed in a grid operator's register of approved installers (§ 13 NAV).

Reinlicht Elektrotechnik is an electrical contractor based in Taufkirchen and is listed in the registers of approved installers of the grid operators in our service area. On site, the focus is the circuit the device will feed into: how it is protected, whether a residual current device is present, what condition the cable and the balcony socket are in and which other loads are connected to it. These documents help at the appointment:

  • Data sheets for the modules and inverter with the manufacturer's statement on DIN VDE V 0126-95.
  • Confirmation of the entry in the Marktstammdatenregister, if the device is already running.
  • Consent from the landlord or the owners' association.
  • Where the meter cabinet is and which fuse supplies the balcony socket, if known.

Frequently asked questions

The most common questions, answered briefly. If yours is not among them, call us or send an enquiry.

Do I still have to register my balcony solar system with the grid operator?

No, as long as it stays within 800 VA and 2,000 watts, no battery is connected and you do not want a feed-in tariff. The grid operator learns about your device through the Marktstammdatenregister.

Can I connect two balcony solar systems to one meter?

Yes, but the limits of 800 VA and 2,000 watts apply to both combined. If you exceed them, the simplified rules no longer apply and the system must be registered with the grid operator.

Will I be paid for the electricity I feed in?

Not by default: balcony solar systems run under unpaid offtake. Payment would only be possible through the standard registration procedure. The Bundesnetzagentur generally considers the extra effort disproportionate to the small amounts involved.

Do I need a new meter cabinet for a balcony solar system?

Only if the existing meter position cannot accommodate the new bidirectional meter. The grid operator replaces the meter; a registered electrical contractor carries out the alteration to the meter position.

As an apartment owner, do I need a resolution of the owners' association?

Yes, the balcony solar system is a structural alteration. Under § 20(2) WEG, however, you are entitled to it, and the association mainly decides on the location and type of mounting.

Sources

Laws, standards and figures change. We checked the information as of the date given; the linked original sources are authoritative. This article does not replace advice on your specific case.

  1. Bundesnetzagentur: FAQ Balkon-Solaranlagen (opens in a new tab) accessed on 31 October 2026
  2. Verbraucherzentrale: Gesetze und Normen für Steckersolar (Stand 21.10.2026) (opens in a new tab) accessed on 31 October 2026
  3. DKE: FAQ zur DIN VDE V 0126-95 (opens in a new tab) accessed on 30 October 2026
  4. DKE: Normauslegung zur DIN VDE V 0126-95 (opens in a new tab) accessed on 30 October 2026
  5. VDE FNN: Steckerfertige PV-Anlagen, Anschluss und Anmeldung (opens in a new tab) accessed on 30 October 2026
  6. Bundesministerium der Justiz: § 5 Marktstammdatenregisterverordnung (opens in a new tab) accessed on 31 October 2026
  7. Bundesministerium der Justiz: § 554 BGB (opens in a new tab) accessed on 30 October 2026
  8. Bundesministerium der Justiz: § 20 Wohnungseigentumsgesetz (opens in a new tab) accessed on 30 October 2026
  9. Bundesministerium der Justiz: § 13 Niederspannungsanschlussverordnung (opens in a new tab) accessed on 30 October 2026

Questions about your installation?

Call us or send an enquiry. We will assess the situation on site and tell you what is needed.

Call now 24/7 emergency service, Phone: +49 151 61844537Request a quote